Aeroflow XPro Xtreme Ignition Products 8.5mm High Performance Black Ignition Leads. Suitable for VF Holden Commodore & HSV LS3 6.2lt V8. Aeroflow has become synonymous with premium quality performance products. Aeroflow’s objective has been to incorporate state-of-the-art manufacturing, aerospace quality materials and rigid quality controls to produce quality performance products at extraordinary value. Aeroflow has taken its forward thinking knowledge to the street, manufacturing a wide range of race quality products to improve street performance and dependability. The Aeroflow 8.5mm XPro Wire is “the” performance wire. Engineered from the inside out, the 8.5 offers everything you have ever wanted in a wire; incredibly low resistance without electronic interference! In a single 12 inch length of XPro Wire there is only 40 – 50 ohms of resistance! That is the lowest resistance of any helically wound wire. To accomplish this, Aeroflow use a copper alloy conductor due to its great voltage carrying capabilities. The low resistance results in less loss in spark energy so more reaches the spark plug. The conductor is wound extremely tight around a special center core. So tight in fact, that there is over 40 feet of conductor wrapped into a single foot of plug wire. This winding procedure, combined with a ferro-magnetic impregnated center core, produces an extremely effective Electro Magnetic Interference (EMI) “choke”. This choke, or suppression capability, keeps the EMI inside the wire where it cannot interfere with other electronics on your vehicle. The outer sleeve that surrounds the conductor assembly is just as impressive. A proprietary blend of silicone and synthetic material produce a sleeve that is highly resistant to high heat as well as abrasion and tears. Aeroflow’s 8.5mm XPro wire sets have a special helically wound core that has just 40-50 ohms of resistance per foot–but with an RFI suppression equal to a 1,500 ohm wire. In fact, each foot of finished wire features 40 ft. Of tightly wound copper for superior conductivity. A tough, 8.5mm synthetic/silicone jacket over an extra-heavy glass braid and dielectric insulator keeps the current guided to the plugs. Underneath the high-temperature boots, dual crimp stainless steel terminals feature snap-locks to ensure a secure fit. Supplied complete with clip on numbered lead markers. Diameter (mm): 8.50mm. Distributor Terminal Ends: Stock. Distributor Boot Color: Black. Distributor Boot Material: Silicone. Spark Plug Boot Ends: Eight multi-angle. Spark Plug Boot Color: Black. Spark Plug Boot Material: Silicone. Conductor Style: Spiral core. Length: Approximately 8 length end to end. Low resistance: 40-50 ohms per foot. To fit LS3 engine type only. Will not fit any other engine type.
