Brand new, genuine Denso ignition wire set for all Holden and HSV LS2, LS3, LS7, L76, L77, L98, LSA, 6.0, 6.2, 7.0L V8 motors. Compatible with NGK RC-HLK816S. Does not include aluminium heat-shields. About Denso Wire Sets. Identical in fit, colour, form, and performance to the original, factory-installed wire set, DENSO ignition wire sets fit right, look right, and work perfectly. Many replacement ignition wire sets are a disappointment: they require too much work to install and don’t produce a quality job. DENSO First Time Fit® wire sets will put the enjoyment back into your weekend tune-up projects. All-Silicone Wires: These ignition wires are SAE J2031 Class E rated, the highest quality wire used in the industry. These wires can withstand temperatures from -40° to 428° F and pass tests covering everything from electrical properties to shrinkage to chemical resistance and accelerated life testing. Pre-cut to Exact Lengths: Each wire in the set is pre-cut to exact length so the wire sets are ready to install right out of the box. This allows the installer to “feel and hear” that a solid connection has been made, even when the connection is in a difficult-to-see location. Strong Connections: Through a patented process, the terminals are attached to provide an extremely strong connection ensuring the cable and boot will not separate during removal and installation. High temperature “Class E” silicone jacket to withstand heat, cold, chemicals and moisture. Reinforcing member for added strength and terminal retention. Silicone insulation for superior dielectric and heat performance. Conductive silicon layer for high temperature performance and EMI/RFI noise suppression. Fiberglass braid for maximum strength. Carbon impregnated fiberglass core for superior support conductivity. Core reinforced with KEVLAR®. Layer impregnated with Ferrite. Wire-wound layer to suppress EMI/RFI noise. This wire set is direct-imported from an authorised Denso supplier in the USA. Buyers are also protected by Australian consumer law.